Magnetic Positioning Logging Meter

Brand

WELL-SUN

Guarantee Period

Response Time

6 - 24h

item

Name

UOM

Quantity

  • Product Information
  • Specifications
  • After-sale Protection
Product Introduction

The magnetic positioning logging meter is an instrument used in positioning measurement in casing downhole operation. The probe used is composed of one coil and four magnetic steels, which are fixed at upper and lower ends of the coil in two groups, making the coil in a constant magnetic field. When the instrument passes section hoop, the magnetic wires of force rearrange, in this case, the coil is in a varying magnetic field, from which an AC signal is induced, while electrical signal is converted into frequency via magnification. The frequency is counted by single chip on the instrument, sent to remote short section during addressing, and then sent to the ground via remote short section code, so as to complete measurement on casing section scoop. Applicable for calibration in casing well downhole positioning.

 

Technical Parameters:

1. Cable requirements: Single core cable 2. Max. working temperature: 175℃. 3. Max. working pressure: 100MPa. 4. Diameter: Ф43mm (1 11/16 "). 5. Transportation length: 505mm (17.99"). 6. Connection length: 410 mm (16.14 "). 7. Zero length: 130.5 mm (5.14 "). 8. Working voltage: 18V (WSTbus). 9. Working current: 20A±3mA. 10. Coupling signal-to-noise ratio: > 5. 11. Logging speed: > 400 m/h. 12. Connection thread: 1 3/16-12UN-2A(B) GO (female/male)

After-sales Service
On-site installation with technological guidance,regular equipment inspection,and training.
We have marketing teams in regions where key accounts located,also we prepare special stock area in the local warehouses for key accounts.to timely provide necessary parts and consumable products.
Problem solving & Complaints settlement.
After-sales Procedures

(Customer Center)Apply
for after-sale service

Solutions released
within 48h

(Customer Center)Apply
Satisfaction survey

Respond within 24h

Execution of the solution

Specifications

Product attribute

Functional use
Accomplished Quality Control System:
To provide with all-around service of quality control, quality guarantee, and authority certification.
Warranty:
Warranty Validity: *** days
During the warranty period, for any products with quality problems, we will provide repair, replacement and return service.
After-sales Service:
On-site installation with technological guidance, regular equipment inspection, and training.
We have marketing teams in regions where key accounts located, also we prepare special stock area in the local warehouses for key accounts, to timely provide necessary parts and consumable products. Problem solving & Complaints settlement
After-sales Procedures:
(Customer Center)Apply
for after-sale service
Solutions released
within 48h
(Customer Center)Apply
Satisfaction survey
Respond within 24h
Execution of the solution
erui_email